Concept VZ1440 Manual De Instrucciones página 37

OPERATING INSTRUCTIONS
The appliance is only intended for the treatment of human hair.
Do not use it for wigs and animals.
1. Gently dry your hair with a towel after washing.
2. Comb your hair. Do not use hair spray, hair gel or other flammable substances.
3. Put a towel around your neck and shoulders to prevent possible burns.
4. Unfold the power cord completely. Connect the appliance plug to the mains.
5. Use the lock/unlock button to unlock the straightener.
6. Slide the switch from 0 to 1.
7. Use the button for setting the temperature to select the desired temperature. The indicator flashes - the appliance
is heating up.
8. The operating temperature is reached after a few seconds.
Straightening long hair
Always hold the appliance by the handle away from skin and eyes, using a mirror.
• Divide your hair into approximately 4 cm wide strands.
• Hold the appliance according to (Fig. 1).
• Start from the roots, place the prepared strand between the straightening plates for a while (Fig. 1).
• Clamp the straightening plates of the appliance and pull slowly from the roots to the ends of the hair (Fig. 2). Repeat
the procedure until your hair is straightened.
Straightening short hair
Proceed as for long hair, but instead of pulling the appliance over your hair, just clamp the hair between the straightening
plates for about 10 seconds.
• After finishing, allow the hair to cool and then comb it.
• After use, switch the appliance off by sliding the switch from 1 to 0. The indicator goes off.
• If you put the appliance down during use, always switch it off and place it on a non-flammable surface.
• If you use the appliance in the bathroom, be sure to switch it off and unplug it immediately after use, as the proximity
of water and the appliance's contact with water is very dangerous, even when the appliance is turned off!
VZ1440
Fig. 1 Fig. 2
EN
37