Aurora AS1018CD Manual Del Usuario página 2

Paper Shredder
Sheet Capacity
Operating Instructions
Installation
Paper Shred Size
Operation
Maintenance
Paper Entry Width
Troubleshooting
Service Center
Credit Card & CD Capacity
Warning
Voltage
Limited Warranty
* ONE FOLDED SHEET OF PAPER EQUATES TO 2 SHEETS OF PAPER
Heavier paper, humidity or other than rate voltage may reduce capacity.
INSTALLATION
Mount the shredder securely to the rim of the waste basket. (FIGURE 1)
A socket-outlet should be near the equipment and be easily accessible.
Connect the power cord to any standard 120 volt AC outlet.
This shredder includes a built-in safety mechanism that requires the shredder to be
correctly mounted on the supplied wastebasket. It is not designed to operate with any other
wastebaskets. An activation switch located on the head unit automatically shuts off the shredder when
it is lifted or removed. The supplied wastebasket activates this switch, which allows the shredder to be
operable. Lining the wastebasket with a plastic bag will interfere and may keep the shredder from
functioning.
Caution: Crosscut shredders have very sharp exposed blades on the underside.
Use care when mounting the shredder on the wastebasket.
2
10 Sheets of 20lb. bond paper*
3/16 in. x 1 15/32 in. pieces
(0.48 cm x 3.7 cm pieces)
9.0 in / 22.9 cm
1 at a time
120V~60Hz / 4.3 A
FIGURE 1
OPERATION
FIGURE 2
Using the switch located on the unit, select one of the following settings by sliding the switch either
left or right. (FIGURE 2)
I
AUTO / ON :
This setting allows the shredder to be automatically started by inserting paper into the
shred opening. Always feed the paper in as straight as possible. When the paper has
passed through, the shredder will automatically stop. (FIGURE 2)
O
OFF :
This setting turns off all features of the shredder. For safety reasons, we recommend that
you leave the shredder in the "Off" position whenever the shredder is unattended or not
in use. (FIGURE 2)
R REV ( REVERSE ):
In the unlikely event of a paper jam, the reverse setting can be used to help clear the cutters
of paper that has not passed through. Never attempt to clear a jam by using the reverse
function until you have emptied the wastebasket. (FIGURE 2)
The green LED light indicates the shredder in "On" and ready for use.
Features a CD/DVD destroyer (FIGURE 3):
Do not hold CD/DVD with finger through the center ring while feeding into the
shredder. Serious injury may occur. Never feed more than one credit card or CD/DVD at a time.
1) Hold the CD/DVD by the edge and feed one at a time, releasing when shredding begins.
2) Shredder will stop when the entire disc has been destroyed.
LED Status indicators:
Power On Paper Overload
(green light)
FIGURE 3
Shredder Not Aligned
(red light) (red light)
CONTINUED NEXT PAGE
3