Tabla de contenido
MAINTENANCE MODE - LCD
Maintenance Mode allows access to service and diagnostic information, as well as provides the ability to adjust certain
program default parameters. To enter Maintenance Mode:
1. Press and hold the
,
2. A beep will sound and "MAINTENANCE MODE" will display momentarily in the Information Window.
3. Release all keys. "SERIAL NO #####" will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in
increments of 1 unit. These keys do not save the new value - see OK Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new
value - see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the QUICK START key.
A complete list of the items that you may display and change in Maintenance Mode:
Item
Vx.xx SUM
LCB V X.XX
UPDATE SOFTWARE
SERIAL NUM
OPER HOURS
DISTANCE
UNITS
and
keys together.
Min
Max
Default
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
0
0
0
0
0
0
0
0
0
-
ENGLISH
-
Notes
Display's primary processor software ver-
sion and checksum. ( V9.58 30014DD8 )
Display's secondary processor software
version and checksum.
Update console software via USB
TreadClimber serial number.
Total operating hours.
Total TreadClimber miles (UNITS=English),
or km (UNITS=Metric).
English = units of pounds, miles, hours, min-
utes, seconds, feet, inches;
Metric = units of kilograms, kilometers,
hours, minutes, seconds, centimeters
Page 22
Tabla de contenido
