Foremost Barcelona FI-BAR7DSRIB-S10 Manual Del Usuario página 3

1
Carefully turn the table top (A) upside down
on a soft surface. Loosely attach the table
legs (C) to table top (A) with short bolts (D)
through lock washers (H) and big flat washers
(E) using hex screw driver (J).
Do not tighten the bolts at this point.
(Figure 1)
2
Loosely attach the leg connector ring (B) to
table legs (C) with long bolts (F) through lock
washers (H) and small flat washers (G) using
hex screw driver (J).
Do not tighten the bolts at this point.
(Figure 2)
3
Check the alignment of all table legs (C), and
adjust if necessary. Once the alignment is
correct and all bolts are in place, tighten all
bolts (D&F) with hex screw driver (J). Care-
fully turn the table to the upright position.
Cover all bolts (D&F) with cover (I ).
(Figure 3)
Figure 1
Figure 2
Figure 3