Ecco 9230 Instrucciones De Instalacion Y Uso

Model 9230
Dual Head Power Supply
for the
Remote Strobe Systems
WARNING!
Failure to install or use this product according to manufacturers recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the
safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he
can operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and
regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
Introduction:
The 9230 Dual Remote Head Power supply is designed
to work with any of ECCO's 9000 series Remote Strobe Heads.
The advanced features include:
• Meets SAE J1318 Class 2
• Sealed, weatherproof connectors
• Epoxy-filled for rugged environments
• Dual and Quad selectable flash modes
• High and Medium selectable intensity modes
• Output short-circuit protection
920-9230-00 Rev. D
Installation and Operation Instructions
Specifications:
Size: 6.4 x 3.1 x 1.6 inches high
Weight: 2.0 lbs
Input voltage: 12/24 VDC systems
Input current: 3.3 A average (12V)
1.4 A average (24V)
Input watts: 46 W maximum
Flash rate: 120 cycles/min (Quad mode)
(Each Strobe 140 cycles/min(Dual mode)(Alternating Pairs)
channel)
Output power: 15 joules (Quad High)
(Each Stobe 11 joules (Quad Medium)
Channel) 13 joules (Dual High)
7 joules (Dual Medium)
Temp range: -30° C to +50° C
Page 1 of 3