HAMPTON BAY HD33680 Guía De Uso Y Cuidado

Please read and save these instructions
PACKAGE CONTENTS
Assembly and Installation
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: Safe for outdoor operation.
WARNING: Do not operate the fixture fitting with a missing or damaged lens or
bulb protector.
WARNING: Install in accordance with all local codes and ordinances.
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
ETL LISTED UNDER MODEL # U000-1924
1
Attaching and installing the light
q Carefully remove the fixture from its protective packaging.
q Attach the head (A) to the post (B) and insert the spike (C) into the
post (B).
LIGHT INTENSITY FUNCTION
q This Flood light comes with a light intensity function which allows you
to change the intensity from LOW to MEDIUM and HIGH (2250 Lumens).
To change the intensity press the button ONCE for LOW, TWICE for
MEDIUM and THREE times for HIGH.
Button
A
B
D
C
D
Part
A
B
C
D
2
Connecting the wires
WARNING: The wire connector (D) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
CAUTION: The wire from the low voltage power unit shall be 12-18 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light fitting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6 in. (15.24 cm).
• Do not submerge fixture in water.
q Place the wire connector (D) on opposite sides of the low voltage
cable (not included) where the fixture will be located.
q Align and fit the main low voltage cable vertically to the slot of the
wire connector (D) as shown.
q Press the wire connector (D) together until fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation
and establish contact. Turn on the power unit. If the light fixture
does not turn on, repeat the previous steps.
q Once the clip-on connector (D) is in place, it is recommended to
wrap it with electrical tape for additional protection.
q CAUTION BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
q After all fixtures are installed, turn on the transformer.
A
B
C
Item #1002 757 122
Model #HD33680
Use and Care Guide
LOW VOLTAGE LED FLOOD LIGHT
Description
Head
Post
Spike
Connector
D
Quantity
1
1
1
1