Operation - Cub Cadet E18J Manual Del Operador

Operation

Starting Engine
WARNING:
is standing near the lawn mower while starting
engine or operating mower. Never run engine
indoors or in enclosed, poorly ventilated areas.
Engine exhaust contains carbon monoxide, an
odorless and deadly gas. Keep hands, feet, hair and
loose clothing away from any moving parts on
engine and lawn mower.
1. Push primer 3 times. Wait about two seconds between
each push. See Fig. 5-1. In temperature below 50°F, prime
5 times. After the engine is warmed up, one prime may be
needed for all temperatures.
2. Standing behind the mower, squeeze and hold the blade
control against upper handle.
3. Recoil Start: Pull the recoil starter lightly until resistance
is felt, then pull rapidly to overcome compression, prevent
kickback, and start the engine. Repeat if necessary. See Fig.
5-1.
NOTE: Do not allow the recoil starter to snap back against
the rope guide.
Electric Start: Turn ignition key to the right to start the
engine. Release the key after the engine starts. See Fig. 5-1.
If engine does not start, it may be necessary to re-prime
the engine.
Stopping Engine
1. Release blade control to stop the engine and blade.
WARNING:
before performing any work on the mower or to
remove the grass catcher.
Using Your Lawn Mower
Be sure lawn is clear of stones, sticks, wire, or other objects
which could damage lawn mower or engine. Such objects could
be accidently thrown by the mower in any direction and cause
serious personal injury to the operator and others.
WARNING:
result in foreign objects being thrown into the eyes,
which can damage your eyes severely. Always wear
safety glasses while operating the mower, or while
performing any adjustments or repairs on it.
1. Once the engine is running, squeeze the drive control
against the upper handle to propel mower.
12
Be sure no one other than the operator
Wait for the blade to stop completely
The operation of any lawn mower can
2
3
Figure 5-1
WARNING:
If you strike a foreign object, stop the
engine. Remove wire from the spark plug,
thoroughly inspect mower for any damage, and
repair damage before restarting and operating.
Extensive vibration of mower during operation is an
indication of damage. The unit should be promptly
inspected and repaired.
Using as Mulcher
For mulching grass, remove the grass catcher and side discharge
chute from the mower. For effective mulching, do not cut wet
grass. If the grass has been allowed to grow in excess of four
inches, mulching is not recommended. Use the grass catcher to
bag clippings instead.
Using Grass Catcher
You can use the grass catcher to collect clippings while you are
operating the mower.
1. Attach grass catcher following instructions in the
"Assembly & Set-Up" section. Grass clippings will
automatically collect in bag as you run mower. Operate
mower till grass bag is full.
2. Stop engine completely by releasing the blade control.
Make sure that the unit has come to a complete stop.
3. Lift discharge door and pull grass bag up and away from
the mower to remove the bag. Dispose of the grass
clippings and reinstall the bag when complete.
5
3
1