Tabla de contenido
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
Prior to installation, inspect the product
for transport damages. After it has been
installed, no transport or surface damage
will be honoured.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Protection against backflow is provided by two
check valves.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.75 GPM (6.6 L/min)
1½" (38 mm)
2¾" (70 mm)
• If the center line of the faucet is more than 1⅛" (30
mm) from the wall or the rear wall of the cabinet,
install support for the hose box.
• The hose box must be attached to the wall, cabinet,
or support. The installer or homeowner must supply
appropriate fasteners.
• If space restraints require it, the hose box can be
tilted a maximum of 20°.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Tabla de contenido
