Information on Grilling and Combined Operation
• As heat radiation is used during grilling and combined operation, please
use only heat-resistant tableware. Plastic containers are not suitable.
• When food is only being grilled, metal or aluminium tableware may
also be used -but not during combined or microwave operation.
• Do not place anything on top of the housing as this becomes hot.
Always leave the ventilation slits uncovered.
• Please use the grilling grid to move the food to be cooked nearer to the
heating element.
Suitable Microwave Tableware
• The ideal material for use in a microwave is transparent and allows the
microwave radiation to heat the food evenly.
• Round / oval dishes and plates are more suitable than rectangular ones
as the food in the corners may overcook.
CAUTION:
Risk of explosion by sealed tableware.
• Open closed containers before cooking or heating.
• Pierce protective plastic foil several times using a fork.
CAUTION: Sparking and fire hazard!
• Microwaves cannot penetrate metal. Accordingly, no metal contain-
ers or plates may be used in microwave operation.
• Do not use any paper dishes made of recycled material as these
may contain small amounts of metal, which may result in sparks or
fires.
The list below is intended to help you select suitable microwave tableware:
Material
Heat-resistant glass vessel
Non-heat-resistant glass vessel
Heat-resistant ceramic vessel/
plate
Plastic vessels suitable for
microwave use
Kitchen roll
Metal or aluminium ovenware
Grilling grid
Aluminium foil and foil containers
*) Combination of microwave with grill.
Notes on Operating and Using the Appliance
What you Should Know about Microwave Operation
• Your device works with microwave radiation, which heats up water
particles in food in a very short time. There is no heat radiation and
therefore hardly any browning.
• Only food should be heated up with this device.
• The device is not suitable for baking in floating fat.
• Only 1 - 2 portions should be heated up at the same time. Otherwise
the microwave will become less efficient.
• Microwaves provide their full energy levels immediately. Pre-heating is
therefore not necessary.
• Never operate the microwave function when the oven is empty.
• The microwave oven does not replace your traditional cooker. It is
used mainly for:
- defrosting deep-frozen food
- rapid warming / heating of food or drinks
- cooking meals.
54
PC-MWG1117_IM
Suitable for
Microwave Grill Combination *
yes
yes
yes
no
no
no
yes
yes
yes
yes
no
no
yes
no
no
no
yes
no
no
yes
no
no
yes
no
Notes on Operating the Appliance
• The display shows the selected program.
• After a program has started, the display will show a countdown timer
indicating the remaining operating time.
• The appliance emits the following acoustic signals:
One beep:
- When being connected to the mains supply;
- When pressing a button;
- When the program settings reset automatically, in
the case that the program selection has not been
completed after approx. 15 seconds.
- When opening the door after the end of a program
Two beeps: When pressing the wrong button. Check your input.
Four beeps: Program finished. The appliance turns off and the display
shows "End". These beeps repeat every 2 minutes until
you open the door or press the STOP / CANCEL button.
Initial Operation
Installation Instructions
• Install the appliance with the back of the appliance facing the wall.
• Maintain the following safety clearances:
- 10 cm to the back
- 5 cm to both sides
- 20 cm to the top of the microwave.
• In order to avoid interference with the operation of other devices, do
not place your device near other electronic devices.
Preparation
• Use the handle to open the door.
• Remove any accessories from the cooking chamber and unpack.
Place the roller ring on the recessed area of the cooking chamber and
move it back and forth until it locks into place.
• Place the turntable on the roller ring in such a way that the turntable
cannot be moved anymore.
• Check the device for any visible damage, particularly in the area of the
door. If any damage is found, the machine must not be used.
• Remove any protective foils that may be adhered to the housing.
• Make sure the mains voltage to be used corresponds to the voltage of
the appliance. Check the rating label for specifications.
• Insert the mains plug into a properly installed power socket.
CAUTION:
• Do not remove any installed parts from inside the oven or from inside
the door!
• The mica sheet (9) is also part of the appliance and must not be
removed. It protects the electronic component located behind it from
dirt.
NOTE:
If there are manufacturing or oil remains on the enclosure or heating
element, smoke or odor might occur during the beginning operation.
This is normal and will cease after repeated use.
We strongly recommend proceeding as follows:
• Turn on the grill mode and let the device operate several times
without food to be cooked.
• Ensure sufficient ventilation.
Setting the Clock
1. Press the CLOCK / WEIGHT button once or repeatedly in order to
select the 24-hour or 12-hour display mode.
2. Use the dial control to set the desired hour.
3. Confirm your setting by pressing CLOCK / WEIGHT.
4. Use the dial control to set the desired minutes.
5. Press CLOCK / WEIGHT again to apply the new clock setting.
22.11.2016