Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
DESCRIPTION
Portable air impact wrench designed for motorsport
application (Best Practice: Grand Am, GP2, DTM).
LUBRICANT
Hammer
mechanism
grease for Paoli air impact wrench hammer
mechanism.
Air motor lubrication: Very fluid oil for air
tools or Special oil for Paoli air impact wrench
motors.
ENVIRONMENTAL CONDITIONS
Temperature: -5 ° C ÷ + 45 ° C
Storage temperature: 0 ° C ÷ + 40 ° C
Air humidity: <80%
Max Altitude: 2000m from sea level
AIR SUPPLY SYSTEM DIAGRAM
View figure Fig.3.
L It is allowed to use exclusively on industrial
plants with compressed air.
L Make use of a supply system that observes
the indicated pressure values (max 10%
over the maximum value indicated) using an
air pressure regulator supplied by a system
observing the current safety standard, and
that it is subjected to regular checks.
L The components of the supply system must
be designed and constructed in accordance
with the safety requirements contained in
current international standards.
* These performances have been obtained after having tested the wheel gun on a testing-bench, that is on fixed bolts,
which have been tightened for 5 seconds. Please remind that, during the tightening/loosening on a Formula 1 car's wheel
hub you lose most of the torque, due to the hub's spin. Furthermore the performances change depending on the wheel
gun's operating-time on each nut, reminding that the correct operating-time on one single nut is, on average, one second.
** DP 3000 SUPERSPORT Unhanded (UH) version: Maximum free speed is 11.000 RPM (at 20 bar) - Ultimate torque is 2.800 Nm.
*** DP 3000 SUPERSPORT with carbon cover: Weight is 3,93 kg.
ENGLISH
4
OPERATING AND MAINTENANCE MANUAL
lubrication:
Special
INTENDED USE
Assembly air tool for threaded fasteners in the
pit stop service.
Weight (kg)
Length (mm)
Square drive
Air inlet
Supply hose inside diameter
Maximum free speed (RPM)
Max weight recommended
power socket (kg)
Operating air pressure (bar)
Ultimate torque* (Nm)
L Before any work on the supply system, always
check that the line is depressurized (no air
pressure).
L It is recommended to use a whip hose
(flexible hose for compressed air with a
minimum length of 46 cm (18 inch)) with a
threaded male to connected to the air inlet of
the wheel gun, and a male quick disconnect
coupling at the other end.
L Fit a the whip hose to the air pressure regulator
using a specific supply hose.
L Use a supply pipe of minimum inner
diameter 13 mm (1/2 inch) suitable for its
intended use.
4***
235
1"
3/8" BSP
1/2" (13 mm)
11.500** (at 20 bar)
0,70
20 (maximum)
3.000**
