verse SUB SERIE Manual Del Usuario página 7

SUB User's Guide
1
1 & 5. LEFT/RIGHT LINK: sends to the output the same signal coming from LEFT/RIGHT INPUT
connector. This allow the cascade connection of different devices to the same sound source.
2 & 4. LEFT/RIGHT INPUT: XLR input socket for connection of the signal to be amplified.
3. L(MONO)/STEREO: use L(MONO) when using only LEFT INPUT, STEREO, when using both inputs.
6. CONTROL SWITCHES:
» GND LIFT: switch that allows the amplifier ground to be disconnected from the chassis. However,
the speaker ground connection remains unchanged. This is useful in situations where ground loops
occur, causing hissing if more than one device is connected to the same power supply socket.
» PHASE: invert the phase of the input signal.
» X−OVER: insert cross−over filter in the output signal.
» 63/125Hz: switch x−over cut frequency between 63Hz/125Hz.
7. SUB LEVEL: to adjust the signal gain in range from 0 to 10.
8. SIGNAL LED: indicates that the
signal is present.
9. COMP LED: indicates
compressor's activity. If the
signal passes over the safety
threshold, the compressor
guarantees a good quality
playback, without acoustic
distortion, damping the
appropriate signal frequencies.
The system operates in total
safety. If the LED is constantly
on, there is an excess of signal. In this case, please reduce the incoming signal level.
10. PROTECT LED: the internal amplifier is in thermal protection mode due to overheating.
11. ON LED: indicates that the speaker is On.
12. OUTPUT: XLR socket to send signal out. This signal is affected by X−OVER.
4
2 3
8
5
11
9 10
7
6
12