Attachment Operation In Reverse; Adjusting Mower Cutting Height - Simplicity Prestige Serie Manual Del Usuario

OPERATION
Mowing in Reverse (RMO)
If an operator chooses to mow in reverse, the RMO system
can be used. To use the Reverse Mowing Option (RMO)
turn the RMO key after the PTO is engaged. The L.E.D.
light will illuminate, and the operator can then mow in re-
verse. Each time the PTO is engaged the RMO needs to
be reactivated if desired. The key should be removed to
restrict access to the RMO feature.

Attachment Operation in Reverse

If an operator chooses to operate a PTO driven attach-
ment in reverse, the RMO system can be used. To use the
Reverse Mowing Option (RMO) turn the RMO key after the
PTO is engaged. The L.E.D. light will illuminate, and the
operator can then operate the attachment in reverse. Each
time the PTO is disengaged the RMO needs to be reacti-
vated if desired. The key should be removed to restrict ac-
cess to the RMO feature.
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off .
2. Push the lever approximately 2-3/8" (6 cm) to release
the transmission (B, Figure 5).
3. The tractor can now be pushed by hand.
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this unit.
• Do not actuate the transmission release
valve lever while the engine is running.
18

Adjusting Mower Cutting Height

The height-of-cut switch (A, Figure 6) adjusts the mower
cutting height. Press the switch UP to raise the mower cut-
ting height and DOWN to lower the mower cutting height. The cutting height is infi nitely adjustable between 1.0" and
4.0" (2,5 and 10,2 cm).
Attachment Lift Control
The attachment lift control lever (B, Figure 6) raises and
lowers attachments that utilize the tractor's hydraulic lift
cylinder. Pushing the lever forward lowers the attachment
while pulling the lever back raises the attachment.
Attaching a Trailer
The maximum horizontal drawbar force allowed is 444
Newton. The maximum vertical drawbar force is 222
Newton. This equates to a 396 lbs (180 kg) trailer on a 10
degree hill. Secure the trailer with an appropriately sized
clevis pin (A, Figure 7) and clip (B).
Stopping the Tractor and Engine
WARNING
Fuel and its vapors are extremely
fl ammable and explosive.
Fire or explosion can cause severe burns or
death.
• Do not choke the carburetor to stop engine.
1. Return the ground speed control(s) to NEUTRAL.
2. Disengage the PTO and wait for all moving parts to
stop.
3. Set the throttle to FULL.
4. Turn the ignition switch to OFF. Remove the key.