Natural Gas Conversion - Ashley Signature Design P015-900 Manual Del Usuario

Natural gas conversion must be performed only by your natural gas provider or
Service Company. Attempting to perform the natural gas conversion yourself is not safe
and may result in property damage, serious bodily injury or death.
Step 1- At the control panel, disconnect the rubber gas hose from the gas valve.
Step 2- Below the burner, disconnect the aluminum gas tube from the orifice elbow.
Step 3- Remove the 2 M4 nuts from the orifice holder and remove the orifice bracket
assembly.
Step 4- Disconnect the orifice fromthe elbow and replace it with the Natural Gas orifice from
the kit.
Re-fit the orifice bracket assembly onto the holder using the 2 M4 screw s and nuts. Re-
connect the aluminum gas tube into the end of the elbow. Connect your Natural Gas supply
line onto the gas valve at the control panel. BEFORE ATTEMPTING TO USE THE FIREPIT,
check ALL of the connections for leaks using a solution of soapy water. If a leak is discovered
and any bubbles are seen, close the main gas valve
NEVER USE A FLAME TO CHECK FOR GAS LEAKS!
P015-900
NA TUR AL G A S CONVERSION
and re-tighten ALL the
connections.
Page 13 of 49