Troubleshooting; Recycling And Disposal - Mac allister MWDV20L Manual De Instrucciones Y De Seguridad

Troubleshooting

PROBLEM
Missing Parts/Accessories
The vacuum cleaner does
not start
Dust coming out of the
exhaust port
Loss of suction
Static Shock
Mist in exhaust air

Recycling and disposal

Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local Authority or local store for recycling
advice.
> The product comes in a packaging that protects it against transportation damage.
Keep hold of the packaging until you are sure that all the parts have been delivered and the
product is functioning properly. Recycle the packaging afterwards.
POSSIBLE CAUSES
1. They are wrapped up in
the tank.
1. No power at the outlet.
2. Not plugged in correctly.
3. The power cord is cut.
4. On/Off switch defective.
5. Defective Motor.
1. The filter is not installed
or not installed correctly.
2. The filter is damaged.
3. The filter is clogged or
the dust is too fine.
4. The filter doesn't work.
1. The flexible hose fitting
is loose.
2. Filter clogged.
3. Tank or bag full.
4. Hole in the hose.
5. Hose or accessory
clogged.
1. Dry environment.
2. Air's relative humidity
too low.
1. The filter is saturated.
SOLUTIONS
1. Check the tank.
1. Check the power.
2. Unplug/insert the plug
into the outlet again.
3. Have it replaced by an
Authorised Customer
Service Center.
4. Have it repaired by an
Authorised Customer
Service Center.
5. Have it repaired by an
Authorised Customer
Service Center.
1. Install the filter correctly.
2. Replace the filter.
3. Use a more efficient filter.
4. Clean or replace the filter.
1. Tighten the fitting.
2. Clean or replace the filter.
3. Empty or replace them.
4. Replace the hose.
5. Check and unclog as
necessary.
1. Increase humidity. (Where
possible, use a portable or
stationary humidifier.)
2. This is temporary and does
not affect the use of
the vacuum cleaner.
1. Clean or replace the filter.
EN
11