Safety Precautions - HP HD PRO 2 Información De Introducción

Safety precautions

Before using your scanner, read the following safety precautions to make sure you use it safely. Do not carry out any
operations or procedures other than as described in this document, because doing so may result in death, serious
personal injuries, or fire.
Mains connection
• Use the power supply voltage specified on the label. Avoid overloading the scanner's electrical outlet with multiple
devices. Doing so can cause a fire or an electric shock hazard.
• Ensure that the scanner is well grounded. Failure to ground the equipment may result in electrical shock, fire, and
susceptibility to electromagnetic interference.
• Use only the power cord supplied by HP with the scanner. Do not damage, cut, or repair the power cord. A damaged
power cord can cause fire or electric shock. Replace a damaged power cord with an HP-approved power cord.
• Do not set heavy objects on the power cord; do not bend the cables or force them into contorted positions.
• Insert the power cord securely and completely into the wall socket and scanner inlet. A poor connection can cause a fire
or an electric shock hazard.
• Do not handle the power cord with wet hands. Doing so may cause electric shock hazard.
• Observe all warnings and instructions marked on the product.
Scanner operation
• Do not allow metal or liquids (except those used in HP Cleaning kits) to touch the internal parts of the scanner. Doing so
may cause fire, electric shock, or other serious hazards.
• Be careful while the scanner lid is open. Your fingers or hand may be trapped or crushed.
• Unplug the product from the wall before cleaning.
Scanner servicing
• There are no operator-serviceable parts inside the scanner except those covered by HP's Customer Self Repair program
(see http://www.hp.com/go/selfrepair/). Refer servicing of other parts to qualified service personnel.
• Do not disassemble or repair the scanner yourself. There are hazardous voltages inside the scanner that can cause a
fire or electric shock hazard.
Caution
Turn off the equipment and unplug the power cord from the power outlet in any of the following cases:
• If there is smoke or an unusual smell coming from the equipment.
• If the scanner is making an unusual noise not heard during normal operation.
• If a piece of metal or a liquid (not part of cleaning and maintenance routines) touches internal parts of the scanner.
• There is any mechanical or enclosure damage.
• During a thunderstorm.
• During a power failure.
• The power cord or plug is damaged.
• The scanner has been dropped.
• The scanner is not operating normally.
Scanner software
The scanner software is installed in the scanner's panel PC touch screen, and runs automatically when you switch on the
panel PC touch screen. The first screen that you see is divided into three main sections:
• The viewing section on the left, for previewing scanned images; with nine buttons above it that can be used to change
the preview
• The control section on the right, with four tabs containing options for Copy, Scan, Print and Setup tasks
• The toolbar on the bottom, with nine buttons that are described below
Introductory Information
2