Beper VE.112 Manual De Instrucciones página 11

EN
Stand Fan Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
ASSEMBLY INSTRUCTIONS:
• Unscrew the L-shaped screw and remove it and the clamping washer from the end of the base
tube.
• Loosen the height adjustment ring at the top of the base tube and pull out the extension pole to
the desired height, or all the way to the top for maximum height (you may have to push it up from
the bottom if it is tight or stuck). At the desired height, turn the height adjustment ring clockwise to
tighten securely.
• Insert the base tube into the hole on the base, turn over the base and affix the tube using the L-
shaped screw and the clamping washer. Tighten the screw firmly but do not overtighten.
• Set the base on a level, dry surface.
• Lightly loosen the set screw, attach the fan body to the top of the extension pole. Push the body
down as far as possible and then tighten securely with the set screw.
• The motor shaft has the blade cap and guard nut attached. Remove the cap by turning it clockwise
and the nut by turning it anticlockwise.
• Place the rear guard on the front of the motor housing, lining up the two positioning knobs on the
front of the motor housing with the two holes in the rear guard. Make sure that the handle is up the
top. Push the guard in firmly until the three knobs protrude through the holes. Secure the rear guard
by reattaching the guard nut and turning it clockwise to tighten.
• If the motor shaft is covered with a protected sleeve, remove the sleeve.
Slide the blade onto the motor shaft, making sure to match the protrusions on the shaft with the
slots in the blade. Tighten the blade with the blade cap, turning it anticlockwise to tighten it securely.
11