Installing The Strainer - Conglom QK50R Manual Del Usuario

Installation (continued)

INSTALLING THE STRAINER

NOTE:
If you are installing a garbage disposer (not supplied), do not install the
strainer.
- Position the drain (3) and the gasket (4) into the drain
opening of the sink . Silicone or plumbing putty may be used
instead of the gasket (4) .
- Remove any major surface irregularities from around the
bottom of the drain opening .
- Fill both grooves of the bottom seal (5) with silicone sealant
(not supplied) .
- Push the bottom seal (5) with the grooves against the bottom
of the sink such that it is evenly seated .
- Put a small bead of silicone around the flange of the lower
strainer body (6) .
- Press the lower strainer body (6) into the bottom seal (5) and
secure components with the strainer screw (2) .
- Tighten the strainer screw (2) until all gaps are eliminated
and all the components are tightly seated flat against each
other .
- Wipe off excess sealant and allow it to cure as suggested by
the sealant manufacturer before connecting your plumbing .
- Insert the plastic flange (7) into the tail pipe (8), and secure
them to the lower strainer body (6) using the connecting
nut (9) .
Strainer basket (1)
Strainer screw (2)
Drain (3)
Gasket (4)
Sink (A)
Bottom seal (5)
Lower strainer body (6)
Plastic flange (7)
Tail pipe (8)
(not supplied)
Connecting nut (9)
Sink (A)
Silicone
Bottom seal (5)
Lower strainer body (6)
DRAIN INSTALLATION DETAIL
9
Please contact [email protected] or 1-877-333-0098 for further assistance .
Silicone
Silicone
Gasket (4) Drain (3)
Silicone
CONGLOMKB .COM