Troubleshooting; Before Calling For Service - LG DLE2250 Serie Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

36

troUBlEshootInG

TROUBLESHOOTING

Before calling for service

Your dryer is equipped with an automatic error-monitoring system to detect and diagnose problems at an early stage. If your dryer does not
function properly or does not function at all, check the following before you call for service.
Problem
Dryer will not
• Power cord is not properly plugged in.
turn on
• House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
Dryer does not heat
• House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
• Gas supply or service turned off
(gas models only).
Greasy or dirty spots
• Fabric softener used incorrectly.
on clothes
• Clean and dirty clothes being dried
together.
Display shows error
• Thermistor is malfunctioning.
code tE1 or tE2
Lint on clothes
• Lint filter not cleaned properly.
• Laundry not sorted properly.
• Excess static in clothes.
• Dryer is overloaded.
• Tissue, paper, etc., left in pockets.
Excess static in
• Fabric softener not used or used incorrectly.
clothes after drying
• Clothes dried too long (overdried).
• Drying synthetics, permanent press, or
synthetic blends.
Display shows error
• Power cord connection is incorrect.
code PS
Possible Causes
• Make sure that the plug is plugged securely into a grounded outlet matching
the dryer's rating plate.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
• Confirm that the house gas shutoff and the dryer gas shutoff are both fully
open.
• Confirm and follow the instructions provided with your fabric softener.
• Make sure to use your dryer to dry only clean items, because dirty items can
soil clean clothes placed in the same or subsequent loads.
• Stains on dried clothes are actually stains that were not removed during the
washing process.
Make sure that clothes are being completely cleaned according to the
instructions for your washer and detergent.
• Turn off the dryer and call for service.
• Make sure the lint filter is cleaned before every load. With some loads that
produce high amounts of lint, it may be necessary to clean the filter during the
cycle.
• Some fabrics are lint producers (i.e., a fuzzy white cotton towel) and should
be dried separately from clothes that are lint trappers (i.e., a pair of black linen
pants).
• See the Excess static in clothes after drying section below.
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before washing and drying clothes.
• Use a fabric softener to reduce static electricity correctly. Do not use fabric
softeners or products to eliminate static unless recommended by the
manufacturer of the fabric softener or product.
• Overdrying a load of laundry can cause a buildup of static electricity. Adjust
settings and use a shorter drying time, or use SENSOR DRY cycles.
• These materials can cause static buildup. Try using a fabric softener.
• Check the connection of power cord to the terminal block. Refer to 23-27
pages on this manual.
Solutions

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Dle2251 serie

Tabla de contenido