Amplifier Connection - Kohler K-1263840 Guía De Instalación Y Cuidado

Chromatherapy
Connection
Status LED
FRONT
3. Amplifier Connection
CAUTION: Risk of product damage. Use the network cable
provided with the amplifier for installation with baths having more
than one user experience (whirlpool, vibracoustic, air bath, etc.). For
these installations, remove and discard the network cable assembled
to the bath, and replace it with the new network cable. Failure to
replace the network cable may cause irreparable damage to the
amplifier.
IMPORTANT! A network cable is provided with this product.
Depending upon the type of bath product being installed, use this
cable to connect the amplifier and user interface, or to connect the
bath and user interface. Refer to the bath Homeowners Guide or the
bath product page on kohler.com to determine the bath type being
installed.
NOTE: The transducer terminals and wires are numbered to
identify the correct connections. When required, the amplifier can be
removed to aid in the wire connection process.
NOTICE: The circular auxiliary-in port is not an Ethernet
communication port. Do not connect an Ethernet network to the
auxiliary-in port. Use the auxiliary-in port only for a standard
accessory.
Disconnect the power from the amplifier.
If equipped, connect the chromatherapy connector from the bath
to the chromatherapy connection on the amplifier.
Kohler Co.
User Interface
Transducer
Connection
Terminals
Power
Auxiliary-In
Cable
Port
BACK
7 1298482-2-C