How To Ride; How To Stop - Razor Electric Party Pop Manual De Instrucciones

EN

HOW TO RIDE

Standing in the center of the deck engages the foot-controlled power system.
Do not activate the foot-controlled power system (A) (pressure sensor is located under deck grip tape)
unless you are on the Electric Party Pop/Electric Tekno and in a safe, outdoor environment suitable
for riding.
Get on the scooter and place both hands on the handlebars. Kick to start (B).
NOTE: LED lights (on and below deck) will activate when foot-controlled power system is pressed. Light-
up front wheel will activate when product is in motion.
A

HOW TO STOP

For controlled stops, apply the brake by putting pressure on the rear-fender brake. Razor recommends
that you practice applying the brake at various speeds and in an open area free from obstructions
before riding your scooter around others.
GO
ALLER
B
53
NOTE: Pressure on the power
system (center of deck) will
activate the power of the
electric scooter. However,
the motor is designed not
to engage until the electric
scooter is moving at least
5 km/h (3 mph) while
engaging the foot-controlled
power system.
NOTE: As an additional
safety feature, the scooter is
designed to cut power to the
motor when the brake
is applied.
NOTE: Motor will re-engage,
(without having to kick to
start), if brake is released and
foot-controlled power system
is applied before scooter
has slowed down to under 5
km/h (3 mph).
NOTE: Practice riding only
in wide open areas clear
from curbs, parking blocks
and other obstacles.
Impacting the wheels
against any hard surface can
damage the wheels. Wheels
are not covered under the
limited warranty.