Fan Assembly. Pgs - Craftmade Cecilia CC52 Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod.
[Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Determine the length of downrod you wish to
use.Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes
in yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely.
diagram 2.]
Slide canopy over downrod.
Thread safety cable and wires through hanging ball,
then slide hanging ball over downrod--the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging
ball. Be sure stop pin aligns with slots on the inside
of the hanging ball. Tighten set screw securely.
[Refer to diagram 4.]
WARNING: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this
fan.
[Refer to diagram 2.]
[Refer to
[Refer to diagram 3.]
set screw
diagram 1
downrod
clip
diagram 2
canopy
diagram 3
stop pin
diagram 4
page 4
hanging ball
yoke set
screw
and nut
pin
downrod
set screw hole
hanging
stop pin
motor
housing
ball