Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SL151
WARNING:
RISK OF ELECTROCUTION! All electrical
wiring required for installation should be installed by a
qualified electrician.
WARNING:
PINCH HAZARD! FINGERS OR HANDS
BETWEEN MOVING PARTS CAN LEAD TO SEVERE
PERSONAL INJURY! Keep fingers and hands away from
mount when operating.
7.
Press the push button to test the SL151 while it is still in the
pre-test position.
•
Press when the lift is at its extended position and it will
retract.
•
Press when the lift is at its retracted position and it will
extend.
•
Press while the lift is moving and it will stop.
•
Leave SL151 in the open position.
Removing Ceiling Panel
1.
Remove and save screws attaching guide wires to ceiling
panel. (See Figure 5)
Ceiling
Panel
Figure 5
2.
Lift up on each corner of ceiling panel to remove pan from
clips. (See Figure 6) and (See Figure 7)
Ceiling
Panel
Clip
Figure 6
6
Guide Wire
(one on each side)
Remove
Screw
(one on
each side)
Guide
Wire
Ceiling Panel Removed
Figure 7
INSTALLING IN CEILING
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the lift is being
mounted is capable of supporting five times the weight of the
lift and all attached equipment. Reinforce the structure as
required before installing the lift.
NOTE:
The following instructions assume a suitable mounting
structure and surface exists prior to installation and all
power and signal wires and cables have been properly
installed.
Installing in a Suspended Ceiling
NOTE:
The SL151 may be suspended from three 3/8 in.
diameter x 8 in. length (minimum) Grade 2 or better
threaded rods (not provided) which are secured to a
1-5/8" x 1-5/8" 12ga metal framing channel (spanning a
maximum of 5 feet--not provided) by Grade 2 or better
3/8" channel nuts (not provided).
1.
Turn SL151 over and place onto threaded rods, inserting
the rods into the three slots on top of the SL151 housing.
(See Figure 8)
2.
Secure the threaded rods to the SL151 with Grade 2 or
better 3/8 in. jam nuts (not provided) and washers (one of
each on inside and one of each on outside-not provided).
Figure 8
Installation Instructions
(Top view of SL151)
Insert rods into
3 slots
Capítulos
Tabla de contenido
