Filling The Detergent; Using Combined Detergents; Rinse-Aid Usege; Filling The Rinse-Aid And Setting - Icecool LVS45A++ Manual De Instrucciones

4.8. Filling the detergent

Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.

4.9. Using combined detergents

These products should be used according
to the manufacturer's instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to correct level.
4.10. Rinse-aid usage
Rinse-aid makes dishes sparkle and helps
them to dry without spotting. Rinse-aid is
required for stain-free utensils and clear
glasses. Use only rinse-aid for domestic
dishwashers.

4.11. Filling the rinse-aid and setting

To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
• Turn the knob to the "off" position.
• Push the "Start/Pause" button and hold
it down.
• Turn the knob counter clockwise one
step.
• Hold down the "Start/Pause" button until
the LEDs flash twice.
• The machine will display the current
setting.
• Set the level by pushing the "Start/
Pause" button.
• Turn the knob to the "off" position to
save the setting.
The factory setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Level Brightener Dose
1 Rinse-aid not
dispensed
2 1 dose is
dispensed
3 2 doses are
dispensed
4 3 doses are
dispensed
5 4 doses are
dispensed
EN - 12
Indicator
Wash LED is on.
End LED is on.
Start/Pause LED
is on.
Wash and End
LEDs are on.
Wash and Start/
Pause LEDs are on.