Idiomas disponibles
Idiomas disponibles
3
1 2 3 4 5
DRV
NEMA® RECEPTACLE (OPTIONAL)
STEP 1:
Rotational adjustment of the photo control is
tool-less.
STEP 2:
Engage/install photo control into NEMA®
receptacle on top of the fixture.
STEP 3:
Firmly rotate photo-control with its photo-
eye approximately in the 'N' north direction.
Some photo-controls operate best somewhere
between NW and NE.
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections to the terminal block:
a. For 120/277/347V connect the black fixture lead to the voltage
supply position of the terminal block (Hot 1 for 208/240/480V
wiring).
b. For 120/277/347V connect the white fixture lead to the neutral
supply position of the terminal block or (Hot 2 for 208/240/480V
wiring).
c. Connect the green or green/yellow ground lead to the green wire
position of the terminal block.
Dimming capabilities may be accessible through optional Nema
receptacle.
NOTE: Brown and orange leads on optional NEMA Receptacle are not
used and are capped off. No electrical connection is necessary.
d. If Dimming is an option; connect the violet dimming positive lead
to the supply dimming positive lead. If dimming is not being used
ensure to cap off the violet lead.
e. If Dimming is an option; connect the grey dimming negative lead
to the supply dimming negative lead. If dimming is not being
used ensure to cap off the grey lead.
f.
If dimming through Nema is an option, install photo control with
dimming capabilities.
STEP 2:
Push excess supply wires into pole.
STEP 3:
Close cover, making sure that no wires are pinched and latches are
fully engaged.
© 2018 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
http://lighting.cree.com/warranty for warranty and specifications. Cree
of Cree, Inc. NEMA
is a registered trademark of the National Electrical Manufacturers Association
®
2 of 2
DRV
CRTL
FIELD ADJUSTABLE DIMMING
(OPTIONAL)
NOTE: This luminaire may be provided with
field adjustable dimming. Luminaires leave
the factory adjusted to the maximum setting
specified when ordered. Verify which dimming
module is in the luminaire and visit the product
specification sheet for lumen and power
multipliers for each field adjustable output dim
setting. See Figure 3`.
STEP 1:
The Dimming module is located inside the
luminaire.
and the Cree Logo are registered trademarks
®
STEP 2:
Establish the desired input power multiplier by
referring to the product dimming spec sheet
and turn the switch to the correlating position.
For the half moon shaped dial (Figure 3) the
center of the flat side should be turned to the
desired setting.
STEP 3:
Adjust the Dimming Module, see Figure 3,
to the selected position and close the cover
ensuring no wires are pinched.
NOTE: The Utility Option will be limited to the
highest setting ordered.
TERMINAL
BLOCK
LINE-BLACK
LINE
OR HOT 1
GROUND-GREEN
GREEN
NEUTRAL
NEUTRAL-WHITE
OR HOT 2
OPTIONAL NEMA CONTENT
VIOLET
DIM (+) VIOLET
GREY
DIM (-) GREY
LUMINAIRE
lighting.cree.com
CI379X22R0
