MCZ MASTER 4 Instrucción De Montaje página 20

Check the gas tube, making sure that it is not split, cut or scratched
Check the gas tube expiry date and replace it if necessary.
Do not use the barbecue if the tube is damaged.
Make sure that the gas tube does not develop bends that could obstruct the regular gas fl ow during
use of the barbecue.
Make sure that the gas tube is not under pressure at any point and that it does not touch any part
of the hot barbecue.
Close the grill taps.
Open the cylinder valve and make sure that there are no leaks. Pour a solution of 50% water and
50% liquid soap on all the connections. If you observe bubbles, this means that there is a leak.
The barbecue must not be used until the source of the leak has been repaired!
To stop the leak, you need to tighten all the connection points.
Close the cylinder gas tap as soon as you smell gas!
Perform the gas leak test every time you connect or replace the gas cylinder or tube.
How to replace the cylinder
When connecting or replacing the cylinder, make sure that:
- The operation takes place outdoors.
- There are no naked fl ames in the vicinity.
- The gas tap has been closed.
- The regulator seal is suitable and new
- The gas tube is not under pressure or twisted and does not touch any part of the hot barbecue.
- Only pressure regulators compliant with current laws have been used on the cylinder.
- The gas tube is no more than 1.5 metres long
Note: always make sure that there are no leaks from the connector by using soapy water on all
the connections.
Lighting instructions
Place the barbecue on a fl at surface, far from infl ammable objects such as wooden fences or
overhanging tree branches. Do not use the barbecue in enclosed areas! Once lit, do not move the
barbecue or leave it unattended. Keep the barbecue out of the reach of children and animals. Bear
in mind that hot cooking fat could drip out of the barbecue. The barbecue gets very hot during use.
Use tongs and gloves to handle the cover and other parts. Make sure that the device has cooled
down completely before putting it away.
Attention: the cover must be open when lighting the burner!
Depending on the model, the burner is lit as follows:
- Open the control valve on the gas cylinder, press down the knob on the barbecue control panel
and turn it in an anticlockwise direction until reaching a central position, then press the ignition
button several times, so that it goes click. Or
- Open the control valve on the gas cylinder, press down the knob on the left of the barbecue
control panel and turn it in an anticlockwise direction until you hear a click. After lighting the
burner, you can also light the other burners in order, by pressing down and turning the knob to the
central position.
Warning: if the burner does not light, close the knob by turning it in a clockwise direction, then
close the gas cylinder valve. Wait fi ve minutes before trying to light the burner again.
Preheating
We recommend heating the barbecue for 5 minutes at minimum and then for 10 minutes at maxi-
mum.
Energy saving advice:
Switch off the grill immediately after cooking, preheat the barbecue for 5 minutes at moderate
20