Getting Started; Resetting The Unit; Detaching The Front Panel - Sony CDX-3170 Manual De Instrucciones

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.
Reset button
Notes
• Pressing the reset button will erase all the
memorized program and memory functions.
EN
• When you connect the power supply cord to the
unit or reset the unit, wait for about 10 seconds
before you insert a disc. Do not insert a disc
within these 10 seconds, otherwise, the unit will
not be reset, and you will have to press the reset
button again.

Detaching the front panel

You can detach the front panel of this unit to
prevent the unit from being stolen.
1
Press (OFF).
2
Press (RELEASE) to open up the front
panel. Then slide the front panel a little
to the left, and pull it off towards you.
(RELEASE)
Notes
• Be sure not to drop the panel when detaching it
from the unit.
• If you press (RELEASE) to detach the panel while
the unit is still on, the unit will turn off
automatically to prevent the speakers from
4
being damaged.
(OFF)
Attaching the front panel
Align part A of the front panel to part B of
the unit as illustrated, and push until it clicks.
B
Notes
• Be sure not to attach the front panel upside
down.
• Do not press the front panel hard against the
unit when attaching it. Press it lightly against the
unit.
• Do not press hard or put excessive pressure on
the display window of the front panel.
• Do not expose the front panel to direct sunlight,
heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight
where there may be a considerable rise in
temperature.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will be activated and a beep tone
will be heard for a few seconds (only for cars
with an accessory position on the ignition key
switch). If you connect an optional power
amplifier and do not use the built-in amplifier,
the beep tone will be disabled.
A