Mark MOVILED 1210 B Instrucciones De Usuario página 6

EN
The earth has to be connected. The device must only be connected with an electric installation carried
out in compliance with IEC standards.
OPERATION
After you connected the effect to the mains, The fixture starts running
Stand Alone operation
In the stand alone mode, the fixture can be use without controller
Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one
master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
Addressing
The control board allows you to assign the DMX starting address,
Note;it's necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.
C ONT R O L B O AR D
The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
The main menu is accessed by pressing the Mode/Esc -button, Browse through the submenu by pressing
Up or Down .Press the Enter-button in order to select the desired menu. You can change the selection
by pressing Up or Down, Confirm every selection by pressing the Enter-button. You can leave every
mode by pressing the Mode/Esc-button .The functions provided are described in the following setting.
M EN U M AP
The device has two operation modes, It can be operated in Stand Alone or in DMX controlled
M EN U M AP
DMX Address (DMX address 001-512)
Mode (DMX mode 15 ch, Auto mode1~8,sound mode)
TEST mode (X,Y,Red,Green,Blue,White)
Setting (ID code0-25,X reverse,Y reverse,Fade delay,dmx signal,endcode,temperature
Protection,Temperature,fans seepd,screen protection,screen reverse, factory reset, rest motor,
System info (running time, total running time, software version, run mode, address, temperature
MOVILED 1210 B User Manual/Manual de uso Page 4