Control Board - Mark LED SPOT 183 Instrucciones De Usuario

Addressing
The control board allows you to assign the DMX starting address,
Note;it's necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.

CONTROL BOARD

The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
he main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by pressing
Up or Down .Press the Enter -button in order to select the desired menu. You can change the selection
by pressing Up or Down, Confirm every selection by pressing the Enter -button. You can leave every
mode by pressing the Mode/Esc-button .The functions provided are described in the following setting.
M ENU MAP
The device has two operation modes, It can be operated in Stand Alone or in DMX controlled
To set the DMX address code in 3CH DMX Mode
To set the DMX address code in 7CH DMX Mode
To set color fading
To set color changing
To set color pulse changing
Strobe
Auto demo programs
To set sound activation mode
To set slave mode
Note output default setting address code is A001, pan is positive circumrotate
circumrotate LED positively reveal.
Master/slave mode(auto-running sound control)
.This mode will allow you to link up 32 units together without a controller.
.Use standard DMX cables to daisy chain your units together via the DMX connector
LED SPOT 183 User Manual/Manual de uso
tilt is positive
Page 4
EN