Operating The Dryer - LG STEAM DRYER DLEX5955W Guía Del Usuario E Instrucciones De Instalacion

H O W TO U S E

OPERATING THE DRYER

Once you have loaded the dryer:
1 Press the ON/OFF button to turn on the
dryer. The lights around the cycle
selector knob will illuminate.
2 Turn the cycle selector knob to the desired
cycle. The display will show
the preset Dry Level,
Temperature, Time, and
Option settings for that cycle.
3
If you would like to change the settings
for that cycle, press the option button(s)
to display additional settings for that option.
Press the button again to cycle through
the settings until the desired setting is
highlighted.
NOTE: To protect your garments, not every
dry level, temperature, or option is available
with every cycle.
4 Select any additional cycle options, such as
REDUCE STATIC (*DAMP DRY BEEP), EASY
IRON, CUSTOM PROGRAM, WRINKLE
CARE (*RACK DRY), BEEPER ON/OFF by
pressing the button For that option.

Press the START/PAUSE button to begin the
5
cycle. The display will change,
and the dryer will display the
estimated (SENSOR DRY) or set
time (MANUAL DRY) remaining
and start tumbling. To pause the cycle at any
time, open the dryer door or press PAUSE.
To resume the cycle where it was stopped,
press START/PAUSE again.
NOTE: If the dryer has been stopped for
more than 8 minutes, the dryer will turn
off automatically.
When the load is finished, the beeper (if set)
6
will sound. If you have set the WRINKLE
CARE option, the dryer will tumble the load
periodically for up to 3 hours.
To prevent wrinkling, remove items from the
dryer immediately after the end of the cycle.
Always clean the lint filter after every cycle.
7
To clean, pull the lint filter straight up and
roll any lint off the filter with your fingers.
Do not rinse or wash the filter to remove lint.
Push the lint filter firmly back into place.