Setting The User Code - First Alert 1037290 Guía De Instalación Y Operación

Opening Your Safe for the First Time
OPENING DOOR
CAUTION
The user preset code is "159" and then press pound #. Please input the user code
again if the yellow light flashes with three buzzer beeps.
Input your user's code (3 to 8 digits), each press results in
1
one buzzer beep and yellow light flashes.
Press " * " or "#" button, the green light will be on.
2
Rotate the knob clockwise and pull outwards within 5 seconds, the door is
3
opened.
NOTE: An interior LED turns on for 30 seconds after the door is opened.
CLOSING DOOR
Turn the knob counter clockwise to close the door.
1
AUTOMATIC LOCK OUT PERIOD
For added security, the safe will automatically lock out entry if the wrong
password is entered multiple times
3 continuously wrong entries will activate the warning beep for 20 seconds. 1
6 continuously wrong entries will activate the warning beep for 5 minutes.
2
CAUTION
The key pad would be disabled during the beeping. You can only stop the
beeps by opening the safe with emergency key and cut power by removing
the batteries.
5

SETTING THE USER CODE

With the door open, press the reset button once, start setting code when the
1
yellow light goes on.
Input new code (3-8 digits), and press " * " or "#" button to confirm with 2
2
buzzer beeps, which indicates the acceptance and storage of the new code.
If the yellow light flashes with 3 buzzer beeps, the code changing is not
3
effective, and you need to try again.
SETTING MASTER CODE
Open the safe, input "0" twice and press reset button, start setting code
1
when the yellow light goes on.
Input the new master code (3-8 digits), then press " * " or "#" button to
2
confirm, it will be confirmed by 2 beeps and the yellow light flashes two
times, then setting is done successfully..
If the yellow light flashes three times, it means the new code is
3
invalid and should be reset again.
NOTE: The user code is the code that will be used most often, the master code
can be used as a back up code. For example, if the user changes the user code,
the master code will allow the safe to be opened. Write down both codes and
keep in a safe place. You can change both master and user codes.
OPENING THE SAFE WITH THE EMERGENCY KEY
Upon first receipt of the safe, if keypad is not functioning, the user code is
unknown, you can use the emergency key to open the safe.
Remove the cover of the emergency lock.
1
Insert the emergency key, turn it counter clockwise, then
2
turn the handle clockwise to open the door.
Setting the User Code
6