User Interface; How To Start Charging - NOCO Genius G4 Manual De Instrucciones

12 USING THE G4

USER INTERFACE

POWER LED
This LED will remain illuminated
when the unit is ON.
STANDBY LEDs
The STANDBY LED
(Green) illuminates
when a charging
mode has not been
selected.
CHARGE
LEVEL LEDs
Indicates the current
charge level of the
battery.
MODE LEDs
The MODE LEDs
indicate the current
MODE the Bank
is in.
MODE BUTTONS
The MODE button
is used to select
the charging modes
manually.
MASTER POWER BUTTON
This button is used to turn the entire
unit ON of OFF.
ERROR LEDs
The ERROR LED
(Orange) will illuminate
when an error condition,
or reverse polarity, is
present.

HOW TO START CHARGING

1.) Confirm that you have connected the battery clamp or eyelet terminal
connectors properly and the AC power plug is plugged into an electrical outlet.
2.) Press the Power Button to turn the battery charger "ON".
3.) Each battery bank will begin in the STANDBY mode, indicated by a Green
LED. In the STANDBY mode, the battery charger is not outputting any current.
By pressing the MODE button, toggle to the appropriate charge mode, either
6V NORM, 6V COLD/AGM, 12V NORM, or 12V COLD/AGM, depending on the
chemistry of your battery, to begin the charging process.
4.) Depending on the charge mode selected, a Red (for NORM) or Blue (for
COLD/AGM) LED will illuminate the selected charge mode and the CHARGE
LEDs (25%, 50%, 75%, 100%) will begin to illuminate (depending on the health
of the battery), indicating the charging process has started.
5.) When the battery is fully charged, all the CHARGE LEDs will be a solid
color (Red, Red, Yellow, Green), indicating the charge process is completed.
6.) The battery charger can be left connected to the battery at all times to
provide maintenance charging. However, it is good practice to check the
battery periodically.
7.) Repeat this process for each battery bank.
WICKED SMART FEATURE
INITIALIZATION. When the battery charger is plugged into an AC
electrical outlet and connected to a battery, there will be a brief (one- to
three-second) delay, then all LEDs will light up for a half (1/2) second,
to confirm all LEDs are operational. After the initialization, the only LED
that will illuminate is the last mode selected. If not in STANDBY mode,
the battery charger will begin charging after five (5) seconds. The five (5)
second delay allows time to toggle through the charge modes.
Now That's Smart, Wicked Smart.™
USING THE G4
geniuschargers.com
13