Introduction; Operator Safety - Techne RB-5A Manual Del Operador

R e f r i g e r a t e d B a t h s U S E R ' S M A N U A L

INTRODUCTION

Operator Safety

P A G E 8
Read the whole of this book before commencing work with the
unit.
The book applies to a range of Techne refrigerated baths. Hence
paragraphs or sections without a heading or reference apply to all
units while paragraphs or sections with headings apply to specific
units. For other refrigerated units there is a separate booklet.
The Techne fridge units are designed to cool liquids to
temperatures around ambient and below by extracting heat
continuously. The temperature is controlled by a temperature
controller with a heater adding heat as necessary. Depending
upon the circuit and the application this could be a Techne
Thermoregulator, TE-10 series or TU-20 series Each unit, fridge
or controller, has its particular application which should be
considered when setting up a temperature controlled system.
The refrigerated baths have integral baths and have refrigeration
coils within the bath. They are designed to work with Techne
thermoregulators. The Fridge Bath works best when there is a
good flow of liquid over the coil.
All users of Techne equipment must have available the relevant
literature needed to ensure their safety.
It is important that only suitably trained personnel operate this
equipment, in accordance with the instructions contained in this
manual and with general safety standards and procedures.
Techne refrigerated units have been designed to conform to
international safety requirements.
If there is any doubt relating to the proper use of this equipment,
the staff at Techne will be pleased to assist you.