Initial Installation - Sharp AQUOS 4T-B60CJ1U Guía De Configuración

Initial installation

Follow the steps below one by one when using the TV for the first time. Some steps may not be
necessary depending on your TV installation and connection.

Connect an antenna cable to the antenna terminal.
1 Cable without a CATV converter
Cable TV lead-In
2 VHF/UHF antenna
75-ohm coaxial cable (round)
CABLE

Plug the AC cord into the AC outlet.
F-type connector should be fi nger-
NOTICE
tightened only.
When connecting the RF cable to the TV set, do not tighten
F-type connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
75-ohm coaxial cable
• Place the TV close to the AC outlet, and keep the power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH
UN-INSULATED PARTS OF ANY CABLES WITH THE AC CORD
CONNECTED.
The drawings used throughout this model are based on
the 4T-B60CJ1U model.
6
Home antenna terminal
(75-ohm)
Coaxial cable
(commercially available)
Home antenna terminal
(75-ohm)
Coaxial cable
(commercially available)
• Connect the antenna
cable to the TV using one
of the methods in the
illustration as shown (1
or 2)
F-type connector

Press
To TV
antenna
terminal
To TV
antenna
terminal

Run the initial installation.
• Follow the guide on the TV screen
to set the following settings.
 
 
 
 
 
 
on the TV.