Before You Begin - Razor E200 Manual Del Propietário

BEFORE yOU BEGIN

Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 20 minutes for assembly, not including initial charge time.
Allow up to 18 hours for initial charge (see page 3 for charging information)
Charger
Charger
Port
Charger
Plug
Seat
(if applicable)
Required Tools
2.5mm/4mm/5mm key 8mm/10mm/17mm
wrenches
(Included)
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at
www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00AM - 5:00PM Pacific Time.
Valve Extender
(inside grip)
Twist Grip Throttle
Handlebar
Stem
Quick Release
-On/Off switch
-Charger Port
-Reset Button
-Battery
-Motor
-Controller
Phillips
wrenches screw driver
(Included) (Included)
(E200S ONLY)
Brake Lever
Limiter
Front Fork
Valve extender
(Located in right
handlebar grip)
2
WARNING:
DO NOT USE NON-
RAZOR PRODUCTS WITH
YOUR RAZOR ELECTRIC
SCOOTER. The scooter has
been built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may or may
not be compatible.
Bicycle-style tire pump
for Schrader valve tires,
with pressure gauge
(Not Included)