Laser Safety - Ricoh SP C440DN Manual Del Usuario

5
High temperature parts. Turn off the main power and be careful when replac-
ing fusing unit/removing misfed paper.
6
The inside of the machine could be very hot. Do not touch the parts with a
label indicating the "hot surface". Otherwise, an injury might occur.
Power Switch Symbols
The meanings of the symbols for the switches on this machine are as follows:
• :POWER ON.
• :STANDBY.

Laser Safety

This machine complies with the requirements of IEC60825-1:2007 (EN60825-
1:2007) for class 1 laser product. The machine contains two AlGaInP laser di-
odes, 657-663 nanometer wavelength. The beam divergence angle is 16 degrees
(minimum) and 23 degrees (maximum) in the vertical direction, and 7 degrees
(minimum) and 11 degrees (maximum) in the horizontal direction, and laser
beams are generated in Continuous Wave (CW) mode. The maximum output
power of the light source is 15 milliwatt.
The following label is attached on the rear side of the machine:
Caution:
Use of controls or adjustments or performance of procedures other than those
specified in this manual might result in hazardous radiation exposure.
10
BYK145
BYK146