Poulan Pro BVM200 Manual De Instrucciones página 4

Elbow
Tube
Small
Opening
Opening Rib
NOTE: Make sure edge of the small opening
is flush against the flared area of the elbow
tube, and the rib on the elbow tube is on the
bottom.
3. Close the zipper on the bag. Make sure the
zipper is closed completely,
4. Remove blower tube from engine.
roove
5. Insert the elbowtube intothe bloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
_WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.
1. Align the lower vacuum tube as shown.
Push lower vacuum tube into upper vacu-
um tube.
Upper Vacuum -_,.
Tube
4. Hold the vacuum inlet cover open until up-
per vacuum tube is installed.
5. Place the hooks on the upper vacuum tube
on the retaining posts of the unit.
6, Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch,
PIVOT
Inlet Cover
Latch
Hook Post
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver toward
the back of the unit to release the latch
while pulling up on the upper vacuum tube
with your other hand.
Lower Vacuum Tube
2. Insert the tip of a screwdriver into the latch
area of the vacuum inlet.
Latch _=___ Blower
Latch Area
Vacuum
Inlet Cover
3. Gently tilt the handle ofthe screwdriver to-
ward the back of the unit to release the
latch while pulling up on the vacuum inlet
cover with your other hand.
3, Remove the vacuum bag,
4, Close the vacuum inlet cover and make
sure it is latched closed,
5, Reinstall the blower tube (see BLOWER
TUBE ASSEMBLY).
-4-