Prepare Cutout/Cabinet Opening; Install The Microwave Oven - Kenmore 204.23073610-27 Instrucciones De Instalación

Prepare Cutout/Cabinet Opening

1.
On the cutout floor, find and mark the centerline.
2.
Place the bottom duct in the opening, with the flange resting
against the bottom front facing of the opening.
A
D
A. Cutout floor
B. Centerline
C. Bottom duct
3. Align the center arrows on the bottom duct with the centerline
drawn in Step 1 above.
A
A. Bottom duct
B. Center arrows, aligned with centerline
4. Mark the three mounting holes through the bottom duct onto
the cutout floor.
A
A. Short screws (3)
B. Bottom duct mounting holes
B C
E
D. Bottom duct flange
E. Front facing
B
B
5. Using a 7/64" drill bit, drill pilot holes into the three hole marks
shown in the figure above.
6. Realign and install the bottom duct with three short screws.
7. Using a 7/64" drill bit, drill pilot holes through the four bottom
duct flange mounting holes into the bottom front facing of
the cutout/cabinet opening.
A

Install the Microwave Oven

1. Carefully return microwave oven to its upright position.
2. Position microwave oven near cutout opening.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug in microwave oven.
4. Align the rails with the rail guides on the bottom duct.
EN-4
B
A. Bottom duct flange
B. Mounting holes
WARNING
Electrical Shock Hazard
A
B
A. Rail guides
B. Rails