Perel LEDS20RGB Manual Del Usuario página 4

4. Use
4.1 Installation
 Mount the LED strip in the desired location. The LED strip can be cut
every 10 cm (see [A]). The cut ends must be protected to avoid short-
circuits.
 Connect the LED strip to the controller [B2] (connecting tools not
included). Make sure to connect matching wire colours. Do not short-
circuit any wires.
 Connect the included power adaptor to the controller [B1]. Plug the
other end into the mains.
4.2 Use
 Aim the remote control [C] towards the IR LED [B3] of the controller to
control the output of the LED strip.
 Switch the LED strip on or off with the
 Select the desired light output colour by pressing the corresponding
colour button on the remote control.
Note: If you want a different colour, you can define your own using the
DIY buttons. For more information, see further in this manual.
 To increase or decrease output brightness, press the
(8 gradations).
4.3 Using Effects
 Press the effect buttons to generate different effects: Auto, Flash, Fade3
(3 colours), Fade7 (7 colours), Jump3 (3 colours), or Jump7 (7 colours).
 To increase the speed of the effects, press Quick. To decrease the
speed, press Slow.
 To pause the effect, press the
restart.
4.4 Creating Custom Colours
You can define and store up to 6 custom colours using the DIY1->6
buttons. When you press the DIY button, the LED strip will change to your
custom colour. For example, to store a colour for button DIY1:
 Press DIY1.
 Use the coloured
 Press DIY1 again to store the colour. The LED strip will blink once when
the colour is stored correctly.
V. 03 – 22/11/2017
LEDS20RGB
button. Press the button again to
and buttons to mix your own colour.
4
button on the remote control.
or button
©Velleman nv