Installing Pipe In Power Drive - EGAmaster ROSCAMATIC 2 COMBI Manual De Instrucciones

Installing Pipe In Power Drive

1. Check to insure the cutter, reamer and die head is swung to the rear of the carriage.
2. Mark the pipe at the desired length if it is being cut to length.
3. Insert the pipe into the Power Drive so that the end to be worked or the cutting mark is located
about 12 inches to the front of the speed chuck jaws.
4. Insert workpieces less than 2 feet long form the front of the machine. Insert longer pipes through
either end so that the longer section extends out beyond the rear of the Power Drive.
5. Tighten the rear centering device around the pipe by using a counterclockwise rotation of the
handwheel at the rear of the Power Drive. This prevents movement of the pipe that can result in
poor thread quality.
6. Secure the pipe by using repeated and forceful counterclockwise spins of the speed chuck
handwheel at the front of the Power Drive. This action "hammers" the jaws tightly around the
pipe.
Installing dies ( automatic die head)
OPERATING INSTRUCTIONS
size bar
index line
lock screw
throwout lever
Fig 2 - Layout of die head 1/2"-2"
clamp lever
trigger assembly
15