Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Notice: The fan may be used only if it is properly and completely assembled, including the base and the guard
grill. If you have any doubt, have the appliance inspected or assembled by a qualifi ed professional.
Stand
1.
Assemble the cross legs 9 and using the 4 included screws attach the fi xed pedestal to this base 8.
2.
Unscrew the safety nut of the telescopic part from the pedestal 0, to enable to put cover on the pedestal,
which covers the joint of the base and the pedestal.
3.
Extend the telescopic pole 7 to required height and secure it with the safety nut 0.
Fan
1.
Put the rear grill 5 on the body of the motor and attach it so that the tabs fi t into the matching openings.
Secure with nut 4.
2.
Attach the fan propeller 3 on the shaft qf of the motor so that the that the notches match the grooves on
the shaft. Secure with nut 2. Tighten the nut counterclockwise.
3.
Attach the front grill 1 to the rear part of the grill 5 and lock it using clamps. For safety reasons, the grill
has to be secured using the included nuts and bolts screwed into the holes around the perimeter of the
grill (holes for the screws must be at the bottom).
4.
Attach the body of the fan to the telescopic part of the pedestal and secure it with locking screw qs.
USE
Make sure prior to each use that the fan is in good condition and the power cord is not damaged. The appliance
must not be used when the power cord is damaged.
You can control the functions of the fan either using the buttons on the control panel 6, or using remote
control qg. You have to point the remote control at the control panel. Before you use the remote control, insert
in it two AAA batteries (size AAA, not included). Pay attention to correct polarity of the batteries.
Ventilation:
1.
Plug the fan into an electrical outlet and switch it on by pressing ON-SPEED button on the remote control
or on the panel of the device. The fan starts at lowest speed.
2.
Select the desired speed by repeatedly pressing the ON-SPEED. The indicator of the control panel shows
the selected speed: LOW (minimal), MID (medium), HIGH (maximum).
3.
To turn off the fan, press on the remote control or panel of the device the OFF button. Then unplug the
power cord.
Horizontal oscillation (left-right)
Operated by the "SWING" button on the remote control or panel of the device. The proper indicator lights up
on the panel. If you want the movement stopped, press the button again. The indicator "SWING" switches off .
Vertical tilt (up/down)
To set it, grasp the head of the motor and tilt it in the desired direction. You will hear a click indicating the
locking of the head in the chosen position.
Timer
This feature allows you to set the time after which the fan is automatically turned off .
•
Set the timer by repeatedly pressing the button TIMER on the remote control or on the panel of the device.
Every pressing of the button extends the set time by half an hour until the maximum 7,5 hours. The LEDs
on the panel show the set time (0,5h, 1h, 2 h, 4 h). The time is given as a sum of LEDs (for example if the
timer is set for 5,5 hour the LEDs show 0,5h+1h+4h).
•
If you want to deactivate the timer, set the maximum time and press TIMER once again (all LEDs turn off ).
•
To turn off the fan, press on the remote control or panel of the device the OFF button. Then unplug the
power cord.
When you are not using the device, always unplug the power cord from the electrical outlet.
GB
21
Tabla de contenido
