Ki Mobility Rogue ALX Manual De Instrucciones Y Garantía página 22

V. SET UP & USE OF YOUR WHEELCHAIR
F. Rogue ALX - Center of Gravity Adjustment
1. To adjust the center of gravity location, remove both rear wheels.
2. Remove the 6 screws (C) (3 per side) that secure the camber mounts (A) to the seat tubes.
3. Slide the camber mount forward or rearward
along the seat tube to the desired hole location.
By using the slide (B) you can adjust the mount
infinitely within the range of each set of holes.
4. Repeat on the other side.
WARNING: Always use at least two screws when attaching the camber mount to the frame.
WARNING: The camber bar mount is slotted. You must use the Slide (B) when attaching the
mount to the frame.
5. Make sure the mounts on both sides of the frame are adjusted equally on both sides of the
frame before replacing all 6 screws.
6. Once the camber mount clamps are secured, attach the rear wheels, occupy the chair and
maneuver it with a spotter to get a feel for the new adjustment.
WARNING: The more you move your rear wheels forward, the more likely your chair will tip over
backwards. Always make adjustments in small increments and check the stability of your chair
with a spotter to prevent a tip-over. We recommend that you use anti-tip tubes until you adapt to
the change and are sure you are not at risk to tip over.
DANGER: Failure to heed these warnings may cause serious injury or death.
C
A
21
Fig. 5
B