ASROCK 939A8X-M Manual De Instrucciones página 15

2.6 2.6 2.6 Serial A Serial A Serial AT T T T T A (SA Serial A A (SA A (SA A (SAT T T T T A) Hard Disks Installation
2.6 2.6 Serial A A (SA
This motherboard supports Serial ATA (SATA) hard disks and RAID functions
(including RAID0, RAID1, and JBOB), but it doesn't support SATA hot-plug and
SATA RAID hot-swap. This section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
1. If you plan to use RAID 0, RAID 1, or JBOD functions on SATA, SATA
HDDs must be operated in "RAID" mode.
2. "RAID" and "non-RAID" mode are options under "SATA Operation Mode" in
BIOS setup. Please refer to page 28 of User Manual in the support CD for
details. They need different drivers during actual operation.
ASRock 939A8X-M Motherboard
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
1 5 1 5 1 5
1 5 1 5