Remote Control; Cleaning And Maintenance; Technical Data - Beper RI.078 Manual De Instrucciones

Ceramic Tower Fan Heater Use instructions
Switch button
"0" means "OFF"
"I" means "ON"
A B C D

REMOTE CONTROL

The remote control uses a CR2025 - 3V button battery included.
To make it operative, remove the protective film placed near the battery compartment.
The remote control shows the same keys indicated above for the control panel:

CLEANING AND MAINTENANCE

Before carrying out any cleaning operation, make sure that the product is switched off and unplug-
ged from the socket.
For cleaning it is advisable to use only a soft cloth slightly moistened with a little water and neutral
soap.
Do not use abrasive or too aggressive products as they could damage the product.
The product is also equipped with a filter that we recommend cleaning at least once a year.
To clean the filter, do not open the rear grill, but simply clean it with a vacuum cleaner.

TECHNICAL DATA:

Power: 2000W
Power supply: 220-240V ~ 50 / 60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
USE
1, Turn on the product by placing the switch button on the back of
the product on "I", the product will turn on in standby mode.
2, Press the "D" button: the product turns on "ON" (only the fan wor-
ks), pressing the product again the appliance will turn off "OFF" (The
fan will continue to run for about 20 seconds)
3, Press "C", LOW, HIGH, VENTILATION FUNCTION
4, Press "B" button to set the timer, 0.5h, 1.0h, 1.5h ..... 7.5h
Press "B" for about 3 seconds, then the temperature can be set.
The temperature can be set between 18 and 45 ° C. If the set tem-
perature is the same as that of the environment, the product will not
start to work.
5, Press the button "A" to switch on the oscillating function.
6, If the product should fall and / or no longer rest on the ground,
a protection will be activated which will automatically shut off the
product.
Attention: Depending on the selected function, the correspon-
ding indicator will light on the control panel.
12