Tabla de contenido
Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
With the unit unplugged, fill the steam iron with water.
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug in.
Set the temperature to the maximum.
Switch-on the steam control, setting the steam controller in steam position
When the light indicator is off, the steam iron has reached the desired temperature.
When finished, unplug the appliance from the power supply.
CAUTION: Avoid coming in contact with escaping steam.
DRY IRONING
The steam iron can be used on the dry setting with or without water in the water tank, however it is best to avoid having the water tank too full of water while dry ironing.
Set the steam control switch to the „0‟‟ position.
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug it in.
Select the temperature best suited for the fabric to be ironed.
When the light indicator is off, ironing may commence.
When finished, unplug the appliance from the power supply.
CAUTION: If the steam iron has been used for a long time, is hot and there is no water, do not refill it with water until the steam iron has cooled down.
STEAM BURST
Make sure that there is enough water in the water tank.
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug it in.
Set the maximum temperature.
Set the steam controller to off position.
Press the steam button
CAUTION: Hold the steam button pressing not more than 5 seconds to avoid hot liquid leakage.
CLEANING
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.
Clean the exterior with a damp cloth and wipe dry.
Do not use abrasive cleaners.
SELF-CLEANING
It is important to apply the self-cleaning function at least every two weeks to remove impurities, etc.
The harder the water the more the iron should be self-cleaned.
Fill the water reservoir up to the "МАX" position.
Stand the iron on its rear side.
Set the maximum temperature by thermoregulator.
Insert the main plug into the wall socket.
Allow the iron to heat up until the light indicator is off.
Hold the iron horizontally over the sink then turn Steam controller for Self-clean position.
Boiling water and steam will now be ejected from the holes in the soleplate. Impurities are washed with it. Move the iron forwards and backwards while this happened.
9
Tabla de contenido
