Tabla de contenido
EN
Area 1 See figure 8
Superficie 1. Vea la Figura 8
Zone 1 Voir figure 8
Para eliminar la
Vacuum only,
mayor cantidad
after cleaning
de agua posible
each area for
sólo realice la
maximum
aspiración
water removal
después de
limpiar cada
superficie
Figure 8A
Figure 8B
22 - FORM NO. 70416A
MACHINE OPERATING INSTRUCTIONS
How to Clean an Area of Carpet See Figure 8A
To clean an area of carpet, follow this procedure:
1. Start the pump for the solution and the motor for the
2. Begin at the right-hand corner of the carpet.
3. Hold the floor tool at the angle that gives the best
4. Apply pressure to the lever for solution release. Pull
Aspiration
seulement,
après nettoyage
5. To clean the edge of a room, move the tool along the
de chaque zone
pour une
élimination
6. To clean a small area of carpet, clean the carpet in
maximum de
l'eau
7. To remove more liquid from the carpet, make passes
How To Clean A Larger Area Of Carpet See Fig. 8B
To clean a larger area of carpet, follow this procedure:
1. Begin at the right-hand corner of the carpet.
2. Make a pass halfway along the edge of the carpet.
3. Move to the edge of the carpet. Make another pass
4. As you make more passes, repeat one inch of the
5. Make more passes until half of the carpet is cleaned.
6. Move to the right-hand corner of the part of the carpet
7. Make a pass halfway along the edge of the carpet.
8. As you make passes, repeat one inch of the area
9. Make more passes until all of the room is cleaned.
Clarke
WARNING:
Do not use water that is hotter
than 120°F (48°C).
vacuum on the extractor.
vacuum seal between the tool and the carpet.
the tool toward you at a slow, steady speed. To
remove as much solution as possible, release the
lever before you stop moving backward. Push tool
away over the same area while moving tool to next
position. (Repeat process)
baseboard until the edge of all the carpet is cleaned.
sections three feet square. As you make more
passes, repeat one inch of the area already cleaned.
over the area already cleaned, but do not apply
pressure to the lever for the solution.
Pull the tool backward at a steady speed.
next to your first pass.
area already cleaned. If you use a power brush tool,
repeat one inch of the area already cleaned by the
brush. Make each pass four inches different in length
to prevent making a line in the center of the carpet.
To remove more liquid from the carpet, make passes
over the area already cleaned, but do not apply
pressure to the lever for the solution.
not yet cleaned.
already cleaned.
CAUTION:
Clarke will not be held liable for damage
to the carpet, or poor results because of
the operator's lack of ability.
®
B
EXT
®
-100, 100H 150H, 300HV Operator's Manual
Tabla de contenido
