YUNEEC E90 Guia De Inicio Rapido página 4

Gimbal Installing
Assembling
Step 1.
Find the arrow printed on the top of the damping plate, which
indicates the correct direction for installation.
Step 2.
Slide the E90 in the indicated direction all the way into
the mounting slot, until the E90 is secured by the locking clip.
Step 3.
Remove the lens protector.
Step 4.
Insert the Micro SD card.
Disassembling
Step 1.
Find the locking clip which is located in front of the mounting
slot.
Step 2.
Press and hold the locking clip and push the E90 forward
(the direction shown by the arrow).
Binding the E90
Step 1.
Switch on the ST16S followed by the H520 aircraft.
Step 2.
Tap the [ ] on the top right corner on the main interface of
ST16S.
Step 3.
Tap the serial number of the E90 when the following window
pops up. (If multiple Yuneec UAS are used, check the ID
number on the side of each camera to assure correct
camera selection/binding).
Step 4.
Using the password "1234567890", authorize the camera
and tap "OK" to confirm.
NOTICE
If the connection process is delayed, close the pop up
window and then repeat the above steps.
Not Connected
Fly
Takeoff
RTL
Pause
Action
Not Connected
Fly
Select Vehicle to Connect
Takeoff
RTL
E90-821BFA
Pause
Action
Reset All Links Close
Not Connected
Fly
Please enter password for E90-821BFA
Takeoff
ok Cancel
RTL
E90-821BFA Pause
Action
Reset All Links Close
N/A
75%
NO CAMERA
N/A
75%
NO CAMERA
N/A
75%
NO CAMERA