Storage; Specifications - Craftsman ZTS 7500 Manual Del Operador

Zero-turn rear engine riders with electric start 107.27786 (20hp briggs & stratton engine with 42" mower)
Ocultar thumbs Ver también para ZTS 7500:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

STO RAG E
Before
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
• Turn the mower blades OFF, set the ground speed
control levers to START / PARK, & remove the key
from the ignition switch.
Check all fluid levels. Check all maintenance items.
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated
structure.
Fuel vapors can
travel to an ignition
source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a
month, if the battery is left in the unit, disconnect the
negative cable.
it is important to prevent gum deposits from forming in
the essential fuel system parts such as the carburetor,
fuel filter, fuel line, and fuel tank during storage. Also,
alcohol blended fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to the
separation and formation of acids during storage. Acidic
gas can damage the fuel system of an engine while in
storage.
To avoid engine problems use fuel stabilizer, especially
before storage of 30 days or longer.
After
Storage
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Fill with FRESH fuel.
• After starting, allow the engine to warm before
operating.
NOTE: Specifications
are correct at time of printing and are subject to change without notice.
ENGINE:
Make
Model
Horsepower
Displacement
Electrical
System
Oil Capacity
Briggs & Stratton
Intek
20 @ 3600 rpm
30.59 Cu. in (501cc)
12 Volt, 9 amp. Alternator, Battery: 340 CCA
44 Oz. (1.3 L) w/o filter;
48 Oz. (1.42 L) w/filter
TRANSMISSION:
Type
Hydro-Gear
EZT ZC-AHBB-2A7B-1DPX
Hydraulic
Fluid
20w 50 Premium Engine Oil
Continuous
Torque
115 ft. Ibs.
Output
Maximum Weight
340 Ibs
per Axle
CHASSIS:
Fuel Tank
Rear Wheels
Front Wheels
Capacity: 3.25 Gallons (12,3 L)
Tire Size: 18 x 8.5 -8
Inflation Pressure: 10-12 psi (,69-,83 bar)
Tire Size: 11 x 4-5
Inflation Press.: 18-20 psi (1,24-1,30 bar)
The gross power rating for individual gas engine models is labeled in accordance
with SAE (Society of Automotive Engineers)
code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in
accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are dedved at 3600
RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-to-
engine variability, Given both the wide array of products on which engines are placed and the variety of environmental
issues
applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power
equipment (actual "on-site" or net horsepower). This difference is due to a variety of factors including, but not limited to,
accessories
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating
conditions (temperature, humidity, altitude), and engine-to-engine
variability. Due to manufacturing and capacity limitations, Briggs
& Stratton may substitute an engine of higher rated power for this Sedes engine.
3O

Capítulos

Tabla de contenido
loading

Tabla de contenido