Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Precautions ............................................2
Warranty ...................................................2
2-Year Warranty .....................................2
Specifications ...........................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Safety Information
PRECAUTIONS
Please read and understand this entire manual before
attempting to assemble, install, or operate this light
fixture.
This light fixture requires 120-volts AC.
Some codes require installation by a qualified electrician.
This light fixture must be properly grounded.
This light fixture is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
For proper operation, this light fixture should be:
Installed outdoors to a wall or eaves
Installed 8 ft. (2.4 m) above the ground (If the light
fixture is mounted higher than recommended,
aiming the sensor down will reduce the coverage
area.)
Do not leave the "ON-TIME" switch in the "TEST"
position. The frequent ON/OFF cycling of the light
fixture will reduce the life of the bulb
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Warranty
2-YEAR WARRANTY
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com.
Tools Required .......................................3
Hardware Included .................................4
Package Contents ..................................5
Mounting Locations ...............................5
Installation ................................................6
Operation...................................................7
Care and Cleaning ..................................10
Troubleshooting ......................................10
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING: Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from the bulbs.
CAUTION: Keep the bulb holders 30° below horizontal to
avoid water damage and electrical shock.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
NOTICE: Do not connect this light fixture to a dimmer switch or
timer.
2
Capítulos
Tabla de contenido
