Impact Driver Safety; Battery Charger Safety - GMC GID18 Manual Del Usuario

Impact Driver Safety

WARNING: It is imperative to follow all national safety regulations concerning
installation, operation and maintenance.
a) ALWAYS hold the tool by the insulated gripping surfaces. Operations where
the tool, fitted accessories or fasteners may contact hidden 'live' wiring will
make exposed metal parts of the tool 'live' and cause an electric shock
hazard to the operator.
b) DO NOT allow anyone under the age of 18 years to use this tool, and
ensure that operators are qualified and familiar with the operating and safety
instructions.
GB
c) ALWAYS grip the tool firmly, DO NOT overreach, and ensure you won't lose
control. Keep secure footing whilst using an impact driver.
d) Battery chargers are for indoors use only. Ensure that the power supply and
charger are protected against moisture at all times.
e) When using the impact driver, use safety equipment including safety glasses
or shield, ear defenders, and protective clothing including safety gloves.
If the work produces dust wear respiratory protection suitable for the work
being undertaken. A minimum rating of FFP2 is recommended. If operating
the tool causes discomfort in any way, stop immediately and review your
method of use.
f) Ensure that the lighting is adequate.
g) Ensure that the impact driver bit or accessory is securely fixed in the bit
holder. Insecure accessories can be ejected from the machine causing a
hazard.
h) DO NOT exert pressure on to the tool. To do so would shorten its service life.
i) If you are interrupted when operating an impact driver, complete the process
and switch off before looking up.
j) Where possible, use clamps or a vice to hold your work.
k) Examine the bit holder regularly for signs of wear or damage. Have damaged
parts repaired by a qualified service centre.
l) ALWAYS wait until the impact driver has come to a complete stop before
putting it down.
m) Periodically check all nuts, bolts and other fixings and tighten where
necessary.
n) Only use bits and accessories, specifically designed for use with impact
drivers. Conventional bits and accessories may shear off during use, or be
otherwise damaged, potentially ejecting dangerous projectiles.
o) Ensure that fasteners are suitable for impact driver use. Nuts, bolts and
screws that are not suitable for high torque application may be damaged.

Battery Charger Safety

Use the battery charger correctly
• Refer to the section of this manual relating to use of the battery charger
before attempting to charge the battery.
• DO NOT attempt to use the charger with any batteries other than those
supplied. Keep your battery charger clean; foreign objects or dirt may cause
a short or block air vents. Failure to follow these instructions may cause
overheating or fire
• If the supply cord is damaged, it must be replaced by the manufacturer, the
service agent or similarly qualified persons in order to avoid a hazard
WARNING: DO NOT attempt to recharge non-rechargeable batteries.
Battery Safety
WARNING: Li-Ion batteries, if incorrectly used, stored or charged are a fire, burn
and explosion hazard.
• Keep the battery out of reach of children
• ONLY charge Li-Ion batteries using the charger provided or designed
specifically for your product
• ONLY use Li-Ion batteries provided with a product or specifically designed to
be compatible
• Allow batteries to cool for 15 minutes after charging or heavy use. Failure to
follow these instructions may cause overheating or fire
• When not in use batteries should be stored at room temperature
(approximately 20˚C)
• Ensure that battery contacts cannot accidentally short in storage. Keep
batteries clean; foreign objects or dirt may cause a short. Keep away from
other metal objects, for example paperclips, coins, keys, nails and screws
• Under abusive conditions, liquid may be ejected from the battery. This liquid
may cause skin irritation or burns. Avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes, seek medical help
• DO NOT open, disassemble, crush, heat above 60°C or incinerate. Do not
dispose of in fire or similar
8