Using The Control Panel; Using The Remote Control - Whirlpool WHISPURE APR25130L Manual De Uso

Using the Control Panel

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Both filter indicator lights will flash once during a self-
test when the air purifier is turned on or after a power
interruption.
2. Press POWER to turn on the air purifier.
3. Press SPEED to choose the desired fan speed.
4. Press POWER to turn off the air purifier.
LCD Display
PRE HEPA
REPLACE
AIR QUALITY
NEW NEW
A. Sleep Mode icon
B. VOC icon
C. Fan speed icon
Fan Speed
Press SPEED until the indicator light comes on for the desired
speed.
Fan Speed Result
Low Best product sound
Medium Slower cleaning power
High Maximum cleaning power
A B
GOOD
MODERATE
POOR
Sleep Mode
Press SLEEP MODE to set. Sleep Mode runs on Low fan speed
for 8 hours and then returns to previously selected setting. To exit
before 8 hours, press SLEEP MODE, SPEED or POWER.
Filter Status Lights
The pre-filter and HEPA filter status lights on the LCD display will
help you to determine when to change your filters. The status
indicator lights will move up from New to Replace at preset
intervals. When the Replace status has been reached, and the
Replace status light is flashing, replace the filter as indicated. See
"Filter Replacement" in the "Air Purifier Care" section.
VOC and Dust Sensor
Press AUTO on the control panel to automatically start the fan or
set the fan speed based on the quality of the air detected by the
Dust Sensor or the Volatile Organic Compound (VOC) Sensor.
VOC Sensor
The VOC LED and icon are displayed on the air purifier control
panel display.
Dust Sensor
The DUST LED and Air Quality icon are displayed on the air
purifier control panel display.
C
HR
1. Press ON • OFF to turn on the air purifier.
2. Press SLEEP MODE to choose Sleep mode.
3. Press SPEED to choose the desired fan speed.
4. Press the Timer Adjustment plus "+" or minus "-" button to
set the timer from 1 to 18 hours.

Using the Remote Control

5